Nutella heated dispenser

Product Status : 21 Day lead time

Lever-action dispenser with extended lever and stainless steel holder for stability, for the filling of croissants and donuts etc. with Nutella/chocolate sauce.

Dosage adjustable from 12 up to 20 g.

Suitable for 3 L bucket or delivered complete with stainless steel or plastic container.

Also deliverable with heated holder. (Article: EDU-SRW-1KB-3-V-SPEC)

Serve Nutella® straight from this stainless steel  heated dispenser without any mess or fuss.

The Nutella® Foodservice Compatible Heated Dispenser is an innovative solution that will allow you to serve Nutella® directly from Tub. Made in stainless steel is perfect for using Nutella® as topping or filling pastries, in a store or even at home. Imagine yourself dispensing Nutella® in a never seen way before! Just push the lever down and dispense the happiness.

The holder is supplied with 2 lockable clips.
Heating element is 150 Watt suitable for 100-240 voltage.
The temperature is limited to 60°C.
Equipped with an on/off switch.
The holder is supplied with rubber feet.

Weight: 3.4Kg
Material: Stainless Steel
Dimensions: Height 420mm, Width 290mm, Depth 165mm
Diameter: Ø 95mm.
Cord length: 130cm.

Additional Information
Bucket in ‘cold’ condition (room temperature): approximately 25°C.
Ambient temperature: approximately 24°C.

When a full 3Kg Tub is placed on the heating element and the lever-action dispenser is installed,
it takes about 30 minutes before the values below are reached. 

Top of the Nutella® 3Kg Tub: Approximately 26°C
Bottom of the Nutella® 3Kg Tub to 10cm above it: Approximately 53°C 

So it is important to note that the entire content of the 3Kg Tub will not be heated.

After the Nutella® has reached the temperature of ± 53°C and is pumped 2 or 3 times the temperature of the Nutella® in the outlet pipe is about 38°C.

When not used, the temperature in the outlet pipe cools down to ± 27°C within 30 minutes, which does not cause any problems when warm Nutella® will be pumped again.

To be used with Nutella® Chocolate Spread 3kg Catering Tub.

The holder is supplied with 2 lockable clips.

Heating element is 150 Watt suitable for 100-240 voltage.

The temperature is limited to 60°C.

Equipped with an on/off switch.

The holder is supplied with rubber feet.

Weight: 3.4Kg

Material: Stainless Steel

Dimensions: Height 420mm, Width 290mm, Depth 165mm

Diameter: Ø 95mm.

Cord length: 130cm.

Additional Information

Bucket in ‘cold’ condition (room temperature): approximately 25°C.

Ambient temperature: approximately 24°C.

When a full 3Kg Tub is placed on the heating element and the lever-action dispenser is installed,

it takes about 30 minutes before the values below are reached. 

Top of the Nutella® 3Kg Tub: Approximately 26°C

Bottom of the Nutella® 3Kg Tub to 10cm above it: Approximately 53°C 

So it is important to note that the entire content of the 3Kg Tub will not be heated.

After the Nutella® has reached the temperature of ± 53°C and is pumped 2 or 3 times the temperature of the Nutella® in the outlet pipe is about 38°C.

When not used, the temperature in the outlet pipe cools down to ± 27°C within 30 minutes, which does not cause any problems when warm Nutella® will be pumped again. .